Yakry Y27-N RV Backup Camera Wireless Plug and Play, Pre-Wired for Furrion System, Recording Wide View HD 1080P 7'' Touch Key Monitor for Trailer Camper Motorhome Review (2026)

Who the Furrion swap camera fits

The Y27-N is built around one specific installation path: rigs that already have a Furrion pre-wired camera bracket and pigtail wire at the rear. For those owners, this camera is a direct plug-in replacement rather than a project that involves fishing new wire through the frame or drilling extra holes in the cap. That makes it a good match for someone upgrading a factory camera that has failed or gone fuzzy, or a buyer who wants recording added to a system that did not originally have it. Owners without a Furrion bracket are better served by a fully wired kit, since this camera's plug and play design depends on that existing connector being in place. It also suits owners who tow a trailer or fifth wheel behind a truck cab, where a clear rear view matters most when hitching and backing into tight campsites.

Monitor, resolution and night vision

The kit centers on a 7 inch touch key monitor that displays 1080P HD video, noticeably sharper than the analog image many factory Furrion cameras produce. The camera uses infrared lights for night vision, so backing into an unlit campsite or pulling under a carport after dark still shows a usable image rather than a black rectangle. A dual antenna wireless link is used to send video from camera to monitor, which Yakry markets as giving a steadier picture and a faster refresh than single antenna wireless systems, useful for anyone who has dealt with the laggy image common on cheaper wireless backup cameras, especially at highway speed or in tight parking maneuvers.

Recording and expanding the system

Unlike a basic backup-only camera, the Y27-N records footage, so a scrape while backing or a dispute over a parking lot incident has video to review afterward. The monitor also supports adding more cameras beyond the single rear unit included, useful for an owner who later wants a side camera for blind spots or a view of a fifth wheel hitch. Setup is meant to take about half an hour for someone swapping into an existing Furrion mount, since the bracket and pigtail eliminate most of the wiring work that a from-scratch backup camera install requires.

Signal range and where it compares to rivals

Wireless RV backup cameras trade the convenience of no video cable for a signal that has to compete with the metal skin of the rig and whatever else is transmitting nearby. The Y27-N's dual antenna design is intended to reduce this weakness compared with single antenna competitors, but on a very long fifth wheel or toy hauler, the distance between camera and monitor can still be enough to cause occasional stutter or dropout, a limitation shared with similarly priced wireless rivals like the ZEROXCLUB BW7M and Rohent R8, which also depend on a clean wireless path down the length of the rig.

Verdict and who should look elsewhere

Choose the Y27-N if your RV already has a Furrion pre-wired bracket and you want a straightforward upgrade to a 1080P monitor with recording and night vision, without rewiring the rear of the rig. It is a sensible pick for a travel trailer or shorter motorhome where the wireless path from camera to monitor is short and unobstructed. Owners of very long fifth wheels who need the most reliable signal, or anyone without the Furrion bracket already installed, should look at a hardwired system or budget extra time for troubleshooting wireless interference before committing to this camera.

Frequently asked questions